Product Description The SucceX-D Mini F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module. But the real magic of this flight controller lies in its TWIN GYRO configuration. The TwinG uses two identical gyros oriented side by side with one offset 90 degrees from the other. Betaflight uses GYRO FUSION to blend and average the information from both gyros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters can be lowered in most cases as well, which brings a significant for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune. FC // SucceX-D Mini F7 MCU: 216MHz STM32F722 Gyro:2x ICM20689 Blackbox:32MB Betaflight OSD: YES BEC: 5V 2.5A / 9V 2.5A Current sensor scale: 100 Inverter for SBUS input (UART2-RX) Smartaudio & Tramp VTX protocol supported Beeper pad : Yes RSSI input pad: No UARTs:5 Motor outputs: 4 8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5) 6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V) BLHeli32 Telemetry:RX5 Input voltage:recommended 2-6S, MAX 6S Firmware: IFLIGHT_F722_TWING Mounting pattern: 20*20mm φ3 Dimensions: 29*29mm USB type-C Package Included: -SucceX-D Mini F7 TwinG FC -Cable harness for DJI Air Unit -Cable for ESC
Succex-D Mini F7 TwinG 6s
₱2,700.00Price